Haier

Add dependable supplemental heat to your system with genuine Haier heat strips. These factory-fit kits deliver electric heat for heat pump air handlers at a budget-friendly price.

Read more
show more

Haier

Haier electric heat strips are purpose-built components for Haier air handlers, available in 5kW, 8kW, 10kW, 15kW, and 20kW to match your load and electrical capacity. Ideal for adding auxiliary or emergency heat, they’re a smart upgrade for residential, property management, and light commercial spaces. With pricing from $185 to $368, these kits offer reliable warmth without stretching your budget.

Whether you’re a licensed contractor, a DIY-capable homeowner planning a pro install, or a property manager standardizing equipment, these heater kits integrate cleanly with compatible Haier cabinets. Use them to supplement heat pump output in cold snaps, ensure backup heat during defrost or outages, or replace worn elements with size-specific kits that fit right the first time.

Key specs: SEER2 and HSPF2 do not apply to resistance heat strips; efficiency ratings remain tied to your heat pump system. BTU/tonnage is determined by the air handler and coil, while strip heat capacity is rated in kW. Refrigerant type is independent-strips sit in the airflow, not the refrigerant circuit. Staging and voltage requirements vary by model; always verify the air handler’s airflow capability, electrical MCA/MOP, and thermostat support for AUX/E heat.

Top Brands for Haier

This category features genuine Haier heater kits engineered for proper fit, safety controls, and reliable performance with Haier air handlers.

Frequently Asked Questions

  • How do I choose the correct kW size heat strip (5kW, 8kW, 10kW, 15kW, 20kW) for my Haier air handler?

    Match climate and load needs to your air handler’s limits; verify electrical capacity and follow a proper heat load calculation.

  • Are Haier electric heat strips compatible with my specific Haier air handler model?

    Yes-select the kit listed for your exact model and cabinet size; confirm against the unit nameplate and install guide.

  • Do these Haier heat strips require professional installation or can a DIYer install them?

    Professional installation by a licensed HVAC/electrical contractor is strongly recommended and often required by code.

  • What breaker size and wiring are needed for each Haier heat strip kW rating?

    Use the kit’s nameplate MCA/MOP to size the breaker and wire gauge; always follow local electrical codes.

  • Can I add a heat strip to a Haier heat pump for emergency heat?

    Yes; heat strips provide auxiliary/emergency heat during low outdoor temperatures, defrost, or compressor issues.

  • Are there airflow or duct requirements when installing higher kW heat strips?

    Yes; verify the air handler can deliver required CFM for the selected kW to prevent high-limit trips and overheating.

  • What safety limits or controls are included with Haier heat strips?

    Kits include factory high-temperature limit protection and staging/sequencing controls as specified for the model.

  • How do I determine if my thermostat supports auxiliary/backup electric heat?

    Check for AUX/E terminals or a heat pump mode with emergency heat; confirm in the thermostat documentation.

  • Will installing a heat strip affect my system’s SEER2 or HSPF2 ratings?

    No; SEER2/HSPF2 apply to the heat pump. Electric resistance heat operates separately as needed.

  • Do these heat strips work with any refrigerant type, like R‑410A?

    Yes; strips are electric elements in the air stream and are independent of refrigerant type.

Common FAQ Quick Education

Featured Videos