1/4 ODF x 1/4 SAE Swivel Female Flare x Solder Adapter
size is listed as OD (outer-diameter) - to determine nominal size
subtract 1/8''. JB recommends the use of compatible thread sealant and
tightening 2-1/2 turns past hand tight.
uses the highest level of brass consisting of 65% copper and 35% zinc
which means high-tensile strength while resisting corrosion. The forging
process of fittings maximize strength and eliminate cracking. Many
import fittings use less quality brass with lower copper content and as a
result have a much higher failure rate. Vacuum pressures of 5,000 psi
can be handled depending on the size, materials, and conditions. Long
dryseal pipe threads minimize leakage and provide more clearance for
tightening flare nuts.
brass fittings can be used with copper, brass, aluminum, steel, and
plastic tubes providing an acceptable flare can be generated with the
material. JB's heavy-duty ACR tube fittings generally conform to SAE,
ASA and ARI standards for marine, hydraulic, and refrigeration service.
Tube fittings are make and break, have good vibration resistance,
economical and are easy to assemble. JB will provide flare fitting to
SAE standard J513 whenever possible.
Made in the USA
JB Industries machines all brass fittings at their factory in Aurora, Illinois.